For the next data-transfer operation again go to
"Start > Programmes > Tools > Communication >
HyperTerminal"
and the following window pops up:
Fig. 19
This now also shows the file "Photometer.ht".
This file was generated when "Save at ..." was executed in
the HyperTerminal programme at the beginning of this
operation after the parameters were set.
Double-clicking on this file immediately starts the Hyper-
Terminal programme with the correct settings and an active
connection. Naturally the colorimeter should be already
connected and switched on and the self-check routine must
have already ended.
Chapter 5.4 | Page 12 of 19