Description Of Ru-Parameter - KEB COMBIVERT F4-F Applications Manual

ru-Parameter

6.1.4 Description of ru-Parameter

ru. 0 Inverter state
Adr.
2000h
In parameter „inverter status" the actual operating condition of the frequency inverter is displayed. The operating conditions
can be devided into four groups:
1. Ready for operation signals
These signals are given upon completion of initialization and when the frequency inverter is ready for operation:
Display Bus Meaning
noP 0 no Operation
LS 70 Low Speed
2. Process signals
The signals occur during the normal operation of the frequency inverter:
Display Bus Meaning
FAcc 64 Forward Acceleration
FdEc 65 Forward Deceleration
Fcon 66 Forward Constant
rAcc 67 Reverse Acceleration
rdEc 68 Reverse Deceleration
rcon 69 Reverse Constant
rFP 79 Ready for Positioning
PA 80 Positioning Active
SrA 82 Search for
Reference Active
© KEB Antriebstechnik, 1999
All Rights reserved
min max
111
0
1. Ready for operation signals
2. Process signals
3. Fault signals
4. Error messages
- control release (terminal X2.1) not activated
- modulation disabled
- output voltage = 0 V/drive without control
- control release (terminal X2.1) active
- rotation setting is missing
- modulation disabled
- output voltage = 0 V/drive without control
(drive conditions refer to the setpoint value)
- drive accelerates with rotation forward
- drive decelerates with rotation forward
- drive operates with constant speed and rotation forward
- drive accelerates with rotation reverse
- drvie decelerates with rotation reverse
- drive operates with constant speed and rotation reverse
- positioning module active
- drive is in „off"-positon and waits for positioning command
- positioning module active
- drive carries out positioning command
- positioning or synchronous module active
- drive performs reference point run
Name: Basis
KEB COMBIVERT F4-F
Functional Description
-
-
Date
16.03.99
ANTRIEBSTECHNIK
default
-
Chapter Section Page
5
6 1 5
6