KEB COMBIVERT F4-F Applications Manual page 43

CP - Parameter
4.3 CP-Parameter
4.3.1 Operation in
CP-Mode
4.3.2 Factory Setting
© KEB Antriebstechnik, 1998
All Rights reserved
The Customer-Parameters (CP) are a special group of parameter. With the
exception of CP .0 (Password input), they can be defined by the user. The following
Parameters are preset at delivery.
Advantages from it: - operator-friendly for the customer
- critical parameters are protected against maloperation
- low documentation cost for the machine builder
Compared to the Application-Mode the operation in the CP-Mode is easier because
parameter set selection and parameter group selection are unnecessary.
Adjustment of
parameter number
L
START
The following list shows the CP-parameter group predefined by us. The definition
of the CP-parameters is done in the User-Definition-Parameters (ud). How you can
define your own parameters is described in Chapter 6.12 „CP-Parameter Definiti-
on".
Name: Basis
KEB COMBIVERT F4-F
Operation
Adjustment of
FUNCT
parameter value
SPEED
STOP
M
START
Date
15.12.98
ANTRIEBSTECHNIK
L
STOP
M
Chapter Section Page
4 3 3
4
3