Operator Parameters; Figure 12: Operator Parameters; Figure 13: Select Control Board Parameter Group - KEB COMBIVERT G6 Programming Manual

OPeRATOR PARAMeTeRS

5 Operator Parameters
Figure 12:
Figure 13:
20
Inverter parameter
CP mode
Operator parameter
Settings
Operator Parameters
os Operator parameter
dp LCD parameter
Menu Top Bottom
Select control board parameter group
In the following, only the meanings of the parameter values are described. Value
ranges, data length and type; Access mode and the default values can be taken
from COMBIVIS.
Use the operator parameters to configure
the control card, the fieldbus (if available)
and the display.
With the keys <▲> and <▼> select
"Operator parameter" and confirm with
<ENTER>.
The control card parameters are divided
into two groups:
• os - operator system parameters;
Display and setting of the control
board
• dp - LC display parameter; Configu-
ration of the LC display via bus
With the keys <▲> and <▼> select the
corresponding parameter group.
<ENTER> switches to the selected sub-
menu.