Isdn Module Settings - Tieline Merlin PLUS User Manual

termination resistors when required. Please note: U interface ISDN terminations do not
require terminating resistors.
How to Configure ISDN G5 Modules
To configure the codec to dial using ISDN for the first time:
1. Ensure that the correct country setting is configured in your codec via Settings > System >
Country.
2. If you are dialing between two Tieline codecs you normally only need to
dialing program
Web-GUI.
Other more advanced settings can also be configured:
1. Select Settings > Modules > [Select ISDN Module] to adjust ISDN module settings
specific to your codec site. See
here
2. ISDN answering can be configured to suit:
·
Hardware available in the codec, i.e. the number of B channels available.
·
Expected dialing behaviors, e.g. if B channels should bond or not, and whether audio
streams need to use Route tags.
·
The type of call being made, e.g. Tieline (with Tieline Session Data) versus non-Tieline
(sessionless calls).
Adjust answering configuration via Settings > Answering > ISDN Answer Configs > [Select
Config] and see
settings using the HTML5 Toolbox Web-GUI).
12.1

ISDN Module Settings

ISDN settings in the Module menu will determine how each installed module operates at a
particular site. Other answering-related settings are available in the Answering menu via Settings
> Answering > [Select ISDN Config].
Configuring ISDN G5 Modules
1. Press the the SETTINGS
Important Note: You can also configure your ISDN module by pressing the HOME
button to return to the Home screen and select Connect > ISDN. Then use the down
2. Navigate to the module you want to configure and press the
left when looking at the codec rear panel.
© Tieline Pty. Ltd. 2017
via Connect > ISDN. Click
to adjust settings using the HTML5 Toolbox Web-GUI.
ISDN Answering Configuration
navigation button to select Module Configuration and press the
Merlin PLUS User Manual v2.0
here to adjust settings using the HTML5 Toolbox
Configure ISDN Module Settings
for more information, or click
button, then navigate to Modules and press the
configure an ISDN
for more information. Click
here
button.
button.
button. Note: Module 1 is on the
39
to adjust