Tieline Merlin PLUS User Manual page 263

8. Navigate to Server Serial Number
number of the server codec to which you are connecting (or select a previously
entered serial number via
9. Navigate up to Fuse-IP Status and then
between the server and client codecs.
10.
The letter F
codecs have created a Fuse-IP tunnel. Remember Fuse-IP must be enabled on both
codecs.
Please note: double-check all settings on both the server and client codecs if the
message Started, dialing server persists after starting Fuse-IP.
11.Select Fuse-IP as the Via interface with which to connect when creating a program
using the front panel codec menus, or the HTML5 Toolbox Web-GUI
Important Notes:
·
Data is sent by the codec over the newly created 'tunnel' as soon as Fuse-IP is
enabled, even if a connection has not been configured and dialed. Depending on
the number of interfaces being used, the codecs may transmit and receive up
to 24MB of data per hour at each end of the link.
·
The codec remembers the Fuse-IP enabled/disabled state on power up
·
For additional stability it is recommended that a fixed jitter buffer is configured
when streaming using Fuse-IP. The actual jitter buffer depth should account for
the difference in delay between the interfaces and the maximum jitter
© Tieline Pty. Ltd. 2017
History
is displayed on the far right side of the Status Bar to confirm the two
Merlin PLUS User Manual v2.0
and press the button
), then
press the button
press the button
to enter the serial
.
to create a Fuse-IP tunnel
Programs panel
263
.