262
Merlin PLUS User Manual v2.0
Important Note: Ensure Fuse-IP is disabled prior to configuration. Navigate to
Fuse-IP Status
Navigate to Fuse-IP Mode
3.
codec.
Navigate to Bonded Interfaces and
4.
interface in turn and
the bottom of the menu after configuration and select
button.
5. Leave the default Fuse-IP Port as 8999 in most situations unless this port is
already in use, e.g. you have multiple codecs behind a firewall using Fuse-IP,
therefore you need to allocate a different port for each Fuse-IP tunnel. Note: the
port number on the client and server codecs must be the same.
6. Navigate to Inactivity Timeout
predetermined time period for turning the Fuse-IP tunnel off.
press the
configured from 0 to 1440 minutes. Enter 0 to disable the timeout.
7. Navigate to Server Address
address associated with the bonded interfaces at the studio (or select a previously
entered server address via
interfaces have private addresses behind a firewall then port forwarding needs to
be configured. See
forwarding.
and
press the
button to disable Fuse-IP if it is enabled.
and press the
press the
and press the
button to store the new setting
and press the
History
Installing the Codec at the Studio
button to select
press the
button,
to select or deselect interfaces. Navigate to
button
button
. Note: Inactivity Timeout can be
to enter a public static IP
button
), then
press the
Client
if it is the remote
then navigate to each
, then
Done
press the
if you want to adjust the
Adjust the setting and
. Note: if the bonded
button
for more details on port
© Tieline Pty. Ltd. 2017
Need help?
Do you have a question about the Merlin PLUS and is the answer not in the manual?