Tieline Merlin PLUS User Manual page 261

Important Note: Ensure Fuse-IP is disabled prior to configuration. Navigate to
Fuse-IP Status
Navigate down to Fuse-IP Mode
3.
codec is at the studio. Note: the server codec serial number will be displayed and needs to
be entered into the Fuse-IP client codec.
Navigate to Bonded Interfaces and
4.
interface in turn and
the top of the menu after configuration and select
Leave the default Fuse-IP Port as 8999 in most situations unless this port is
5.
already in use, e.g. you have multiple codecs behind a firewall using Fuse-IP,
therefore you need to allocate a different port for each Fuse-IP tunnel. Note: the
port number on the client and server codecs must be the same.
6. The codec is now configured to connect with a client codec over a Fuse-IP tunnel.
Configuring a Fuse-IP Remote Client
1. Press the SETTINGS
2. Select Fuse-IP and press the
© Tieline Pty. Ltd. 2017
and
press the button to disable Fuse-IP if it is enabled.
press the button
button.
button.
Merlin PLUS User Manual v2.0
and press the button to select
press the button,
to select or deselect interfaces. Navigate to
, then
Done
Server
then navigate to each
press the button.
261
if the