Snmp Commands - Dell N1100-ON Reference Manual

SNMP Commands

The SNMP component provides a machine-to-machine interface for the Dell
EMC Networking product family. This includes the ability to configure the
network device, view settings and statistics, and upload or download code or
configuration images. The agent includes a get-bulk command to reduce
network management traffic when retrieving a sequence of Management
Information Base (MIB) variables and an elaborate set of error codes for
improved reporting to the network control station. The extensible and
advanced design of the Dell EMC Networking SNMP makes adding remote
manageability to networked devices undemanding. The agent allows a
network control station to retrieve reports from the networked device. These
reports are based upon the defined objects in the MIB. The agent queries,
reports, and sets MIB variables based upon directions from the network
control station or upon preset conditions.
Dell EMC Networking supports IPv4 SNMP access. Only IPv4 SNMP hosts
and users may be configured.
Commands in this Section
This section explains the following commands:
show snmp
show snmp engineid
show snmp filters
show snmp group
show snmp user
show snmp views
show trapflags
show snmp
Use the show snmp command to display the SNMP communications status.
snmp-server community
snmp-server community-
group
snmp-server contact
snmp-server enable traps
snmp-server engineID local snmp-server view
snmp-server filter
–
Switch Management Commands
snmp-server group
snmp-server host
snmp-server location
snmp-server user
snmp-server v3-host
snmp-server source-
interface
2090