Dell N1100-ON Reference Manual page 2104

Default Configuration
SNMP authentication, link, multiple-user, spanning-tree, dot1q, and ACL
traps are enabled by default. Port-security traps are enabled by default.
Command Mode
Global Configuration mode.
User Guidelines
Use the command with no parameters to globally enable sending of traps. Use
the no form of the command with no parameters to globally disable sending
of traps without changing the configured traps.
Refer to the description of the global configuration mode buffer command
for setting the rising and falling thresholds for the sending of the message
buffer trap.
Refer to the description of the Global Configuration mode process cpu
command for setting the rising and falling thresholds for the sending of the
CPU occupancy trap.
Command History
Introduced in version 6.2.0.1 firmware.
Example
The following example displays the options for the snmp-server enable traps
command.
console(config)#snmp-server enable traps ?
<cr>
acl
all
auto-copy-sw
bgp
buffers
captive-portal
cpu
dot1q
dvmrp
Press enter to execute the command.
Enable/Disable traps for access control lists.
Enable/Disable all Traps.
Enable/Disable auto copy of code if there is a
version mismatch.
Enable BGP traps.
Configure Mbuf threshold traps.
Enable/Disable SNMP traps for CP system events.
Configure CPU threshold traps.
Enable/Disable switch level Dot1q trap flag.
Enable/Disable traps for distance vector multicast
routing protocol.
Switch Management Commands
2104