ABB REG670 Applications Manual page 98

Section 4
Analog inputs
92
Where:
1) shows how to connect the secondary side of neutral point VT to one VT input in the IED.
2) is the TRM or AIM where this voltage input is located. For this voltage input the following
setting values shall be entered:
6.6
= =
VTprim 3.81
3
EQUATION1933 V1 EN

VT sec 100 V
EQUATION1934 V2 EN
Inside the IED, only the ratio of these two parameters is used. It shall be noted that the ratio
of the entered values exactly corresponds to ratio of the neutral point VT.
3) shows that in this example the first three input channel of the preprocessing block is not
connected in SMT tool or ACT tool.
4) shows the connection made in Signal Matrix Tool (SMT), Application configuration tool
(ACT), which connects this voltage input to the fourth input channel of the preprocessing
function block 5).
5) is a preprocessing block that has the task to digitally filter the connected analog inputs and
calculate:
• fundamental frequency phasors for all four input channels
• harmonic content for all four input channels
• positive, negative and zero sequence quantities by using the fundamental frequency
phasors for the first three input channels (channel one taken as reference for sequence
quantities)
These calculated values are then available for all built-in protection and control functions
within the IED, which are connected to this preprocessing function block in the configuration
tool. For this application, most of the preprocessing settings can be left to the default values.
If frequency tracking and compensation is required (this feature is typically required only for
IEDs installed in the generating stations) then the setting parameters
set accordingly.
Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062
U shall be connected to the IED.
0
kV
1MRK 502 071-UEN -
(Equation 12)
(Equation 13)
DFTReference shall be
Application manual