Logical Signal Status Report Binstatrep - ABB REG670 Applications Manual

Section 17
Monitoring
17.7
17.7.1
17.7.2
650
• Binary signals: Use only relevant signals to start the recording that is, protection
trip, carrier receive and/or start signals.
• Analog signals: The level triggering should be used with great care, since
unfortunate settings will cause enormously number of recordings. If nevertheless
analog input triggering is used, chose settings by a sufficient margin from normal
operation values. Phase voltages are not recommended for trigging.
There is a risk of flash wear out if the disturbance report triggers too
often.
Remember that values of parameters set elsewhere are linked to the information on a
report. Such parameters are, for example, station and object identifiers, CT and VT
ratios.

Logical signal status report BINSTATREP

Identification
Function description
Logical signal status report
Application
The Logical signal status report (BINSTATREP) function makes it possible to poll
signals from various other function blocks.
BINSTATREP has 16 inputs and 16 outputs. The output status follows the inputs and
can be read from the local HMI or via SPA communication.
When an input is set, the respective output is set for a user defined time. If the input
signal remains set for a longer period, the output will remain set until the input signal
resets.
INPUTn
OUTPUTn
IEC09000732 V1 EN
Figure 314: BINSTATREP logical diagram
Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062
IEC 61850 IEC 60617
identification identification
BINSTATREP
t
IEC09000732-1-en.vsd
1MRK 502 071-UEN -
ANSI/IEEE C37.2
device number
- -
t
Application manual