Automationbits, Command Function For Dnp3.0 Autobits - ABB REG670 Applications Manual

1MRK 502 071-UEN -
15.9
15.9.1
15.9.2
15.9.3
15.10
15.10.1
Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062
Application manual
AutomationBits, command function for DNP3.0
AUTOBITS
Identification
Function description
AutomationBits, command function for
DNP3
Application
Automation bits, command function for DNP3 (AUTOBITS) is used within PCM600
in order to get into the configuration the commands coming through the DNP3.0
protocol.The AUTOBITS function plays the same role as functions GOOSEBINRCV
(for IEC 61850) and MULTICMDRCV (for LON).AUTOBITS function block have
32 individual outputs which each can be mapped as a Binary Output point in DNP3.
The output is operated by a "Object 12" in DNP3. This object contains parameters for
control-code, count, on-time and off-time. To operate an AUTOBITS output point,
send a control-code of latch-On, latch-Off, pulse-On, pulse-Off, Trip or Close. The
remaining parameters are regarded as appropriate. For example, pulse-On, on-
time=100, off-time=300, count=5 would give 5 positive 100 ms pulses, 300 ms apart.
For description of the DNP3 protocol implementation, refer to the Communication
manual.
Setting guidelines
AUTOBITS function block has one setting, (Operation: On/Off) enabling or disabling
the function. These names will be seen in the DNP3 communication management tool
in PCM600.
Single command, 16 signals SINGLECMD
Identification
Function description
Single command, 16 signals
IEC 61850 IEC 60617
identification identification
AUTOBITS -
IEC 61850 IEC 60617
identification identification
SINGLECMD -
Section 15
Control
ANSI/IEEE C37.2
device number
-
ANSI/IEEE C37.2
device number
-
595