Setting Guidelines - ABB REG670 Applications Manual

Section 19
Ethernet-based communication
19.3.2
19.4
19.4.1
19.4.2
680
IEC17000044 V1 EN
Figure 321: Merging unit

Setting guidelines

For information on the merging unit setting guidelines, see section
61850-9-2LE communication
Routes
Application
Setting up a route enables communication to a device that is located in another
subnetwork. Routing is used when the destination device is not in the same
subnetwork as the default gateway.
The route specifies that when a package is sent to the destination device it should be
sent through the selected router. If no route is specified the source device will not find
the destination device.
Setting guidelines
Routes are configured using the Ethernet configuration tool in PCM600.
Operation for the route can be set to On/Off by checking and unchecking the check-
box in the operation column.
Gateway specifies the address of the gateway.
Destination specifies the destination.
Destination subnet mask specifies the subnetwork mask of the destination.
Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062
IEC17000044-1-en.vsdx
protocol.
1MRK 502 071-UEN -
IEC/UCA
Application manual