Protocol Reporting Via Ieee 1344 And C37.118 Pmureport - ABB REG670 Applications Manual

1MRK 502 071-UEN -
6.2
6.2.1
6.2.2
Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062
Application manual
In case of multicast IP, it will be the network switches and routers that take care of
replicating the packet to reach multiple receivers. Multicast mechanism uses network
infrastructure efficiently by requiring the IED to send a packet only once, even if it
needs to be delivered to a large number of receivers.
If there are more than one UDP client group defined as multicast, the user shall set
different multicast IP addresses for each UDP group.
The PMU clients receiving the UDP frames can also connect to the IED to request
(command frame) config frame 1, config frame 2, config frame 3, or header frame, and
to disable/enable real time data. This can be done by connecting to the TCP port
selected in TCPportUDPdataCtrl[x] for each UDP group. This connection is done
using TCP. The IED allows 4 concurrent client connections for every
TCPportUDPdataCtrl[x] port (for each UDP client group[x]).
If the client tries to connect on TCPportUDPdataCtrl[x] port using a PMU-ID other
than what is configured for that PMUREPORT instance (PMUReportUDP[x]), then
that client is immediately disconnected and the UDPCtrlCfgErrCnt is incremented in
PMU Diagnostics on LHMI at Main menu/Diagnostics/Communication/PMU
diagnostics/PMUSTATUS:1
Even if the parameter SendDataUDP[x] is set to Off it is still possible for the clients
to connect on the TCP port and request the configuration frames.
Protocol reporting via IEEE 1344 and C37.118
PMUREPORT
Identification
Function description
Protocol reporting via IEEE 1344 and
C37.118
Application
The phasor measurement reporting block moves the phasor calculations into an IEEE
C37.118 and/or IEEE 1344 synchrophasor frame format. The PMUREPORT block
contains parameters for PMU performance class and reporting rate, the IDCODE and
Global PMU ID, format of the data streamed through the protocol, the type of reported
synchrophasors, as well as settings for reporting analog and digital signals.
The message generated by the PMUREPORT function block is set in accordance with
the IEEE C37.118 and/or IEEE 1344 standards.
There are settings for Phasor type (positive sequence, negative sequence or zero
sequence in case of 3-phase phasor and L1, L2 or L3 in case of single phase phasor),
Wide area measurement system
IEC 61850 IEC 60617
identification identification
PMUREPORT -
Section 6
ANSI/IEEE C37.2
device number
-
107