Figure 10-6 Trigger Link Connections - Keithley 2500 User Manual

10-10 Triggering
The Trigger Link connections for this test system are shown in
of the Model 2500 is connected to Trigger Link (IN or OUT) of the switching mainframe.
Note that with the default trigger settings of the switching mainframe, line #1 is an input,
and line #2 is an output.
Figure 10-6
Trigger link connections
CHANNEL 1
VOLTAGE SOURCE
OUTPUT CHANNEL 1
For this example, the Model 2500 and Switching Mainframe are configured as follows.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
7001 or 7002 Switch System
WARNING: WARNING: WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS, SERVICE BY QUALIFIED PERSONNEL ONLY. NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY. NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
MADE IN USA
CAUTION: CAUTION:
CAUTION: FOR CONTINUED PROTECTION AGAINST FIRE HAZARD, REPLACE FUSE WITH SAME TYPE AND RATING
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
Trigger
Link
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS, SERVICE BY QUALIFIED PERSONNEL ONLY.
RATINGS MAX
100V @ 20mA
COMMON
MADE IN
MODE
U.S.A.
200V
INPUT INPUT
CHANNEL 2
!
TRIGGER LINK
LINE RATING
CAT I
RATINGS MAX
100V @ 20mA
FUSE
630 mAT
(SB)
!
315 mAT
VOLTAGE SOURCE
(SB)
OUTPUT CHANNEL 2
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD, REPLACE FUSE WITH SAME TYPE AND RATING
Model 2500
Models 2500 and 2502 User's Manual
IN
OUT
Trigger
Link
Trigger
Link Cable
(8501)
IEEE-488
(CHANGE IEEE ADDRESS
WITH FRONT PANEL MENU)
DIGITAL I/O
RS-232
50, 60Hz
60 VA MAX
LINE
100 VAC
120 VAC
220 VAC
240 VAC
Figure 10-6. Trigger Link
.
.