Performing Limit Tests; Step 1. Configure Test System; Step 2. Configure Bias Source And Measure Functions - Keithley 2500 User Manual

11-18 Limit Testing
Figure 11-10
Limits configuration menu tree
Digout
Auto
Mode
Size
Clear

Performing limit tests

Perform the following steps to run limit tests:
Step 1. Configure test system.
As previously explained in Section 2, your test system could be as simple as connecting
one or two DUTs to the Model 2500 or could employ the use of a handler for binning
operations. Adding a scanner to the test system allows you to test multiple devices. Make
sure that the Digital I/O is configured appropriately for the handler you are using.
Step 2. Configure bias source and measure functions.
Configure the Model 2500 for the desired operations as follows:
1. Select the desired source channel by pressing SRC1 or SRC2.
2. Set the source level to the desired value.
3. Press MSR1 or MSR2 to select the desired measurement channel, then choose the
desired measurement range.
Refer to
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
H/W
Limits 1,2
Fail
Control
Mode
Control
Section 3, "Basic Operation,"
Models 2500 and 2502 User's Manual
Config
Limit
S/W
Pass
Limits
LIM3-6 Feed
HILIM
LOLIM
for more information.
EOT
Mode
/BUSY
BUSY EOT
/EOT