Read Version Of Scpi Standard; Version; Rs-232 Interface; Local - Keithley 2500 User Manual

Models 2500 and 2502 User's Manual

Read version of SCPI standard

VERSion?

:SYSTem:VERSion?
Description

RS-232 interface

NOTE

LOCal

:SYSTem:LOCal
Description

REMote

:SYSTem:REMote
Description
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
The queue for the :KEY? query command can only hold one key-press.
When :KEY? is sent over the bus, and the Model 2500 is addressed to
talk, the key-press code number for the last key pressed (either physi-
cally or with :KEY) is sent to the computer.
The key-press code number for the last key pressed (either physically or
with :key) is sent to the computer.
This query command is used to read the version of the SCPI standard
being used by the Model 2500. Example code:
1996.0
The above response message indicates the version of the SCPI standard.
The following commands are intended for use over the RS-232 interface, but
they can also be used over the GPIB.
Normally, during RS-232 communications, front panel keys are opera-
tional. However, the user may wish to lock out front panel keys during
RS-232 communications. See RWLock.
This action command is used to remove the Model 2500 from the
remote state and enables the operation of front panel keys in a manner
similar to the GPIB GTL command.
This action command is used to place the Model 2500 in the remote
state in a manner similar to the GPIB REN command. In remote, the
front panel keys will be locked out if local lockout is asserted. See
"RWLock," page 17-86.
SCPI Command Reference
Read SCPI version
Take Model 2500 out of remote
Place the Model 2500 in remote
17-85