Figure 13-3 Ieee-488 And Rs-232 Connector Location - Keithley 2500 User Manual

Models 2500 and 2502 User's Manual
To avoid possible mechanical damage, stack no more than three connectors on any one
unit.
NOTE
To connect the Model 2500 to the IEEE-488 bus, follow these steps:
1. Line up the cable connector with the connector located on the rear panel. The connec-
tor is designed so it will fit only one way.
488 connector.
2. Tighten the screws securely, making sure not to overtighten them.
Figure 13-3
IEEE-488 and RS-232 connector location
VOLTAGE SOURCE
OUTPUT CHANNEL 1
3. Connect any additional connectors from other instruments as required for your
application.
4. Make sure the other end of the cable is properly connected to the controller. Most con-
trollers are equipped with an IEEE-488 style connector, but a few may require a differ-
ent type of connecting cable. See your controller's instruction manual for information
about properly connecting to the IEEE-488 bus.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To minimize interference caused by electromagnetic radiation, use only shielded
IEEE-488 cables. Available shielded cables from Keithley are Models 7007-1
and 7007-2.
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS, SERVICE BY QUALIFIED PERSONNEL ONLY.
RATINGS MAX
100V @ 20mA
COMMON
MADE IN
MODE
U.S.A.
200V
INPUT INPUT
CHANNEL 1 CHANNEL 2
!
TRIGGER LINK
I
CAT
RATINGS MAX
100V @ 20mA
VOLTAGE SOURCE
OUTPUT CHANNEL 2
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD, REPLACE FUSE WITH SAME TYPE AND RATING
Figure 13-3
RS-232
Connector
DIGITAL I/O
RS-232
LINE RATING
50, 60Hz
60 VA MAX
FUSE LINE
630 mAT 100 VAC
(SB) 120 VAC
!
315 mAT 220 VAC
(SB) 240 VAC
Model 2500
Remote Operations
shows the location of the IEEE-
IEEE-488
Connector
IEEE-488
(CHANGE IEEE ADDRESS
WITH FRONT PANEL MENU)
.
13-5