Keithley 2500 User Manual page 396

Models 2500 and 2502 User's Manual
Table E-1
IEEE-488 documentation requirements
(1) IEEE-488 Interface Function Codes.
(2) Behavior of Model 2500 when the address is set outside
the range 0-30.
(3) Behavior of Model 2500 when valid address is entered.
(4) Power-On Setup Conditions.
(5) Message Exchange Options:
(a) Input buffer size.
(b) Queries that return more than one response message
unit.
(c) Queries that generate a response when parsed.
(d) Queries that generate a response when read.
(e) Coupled commands.
(6) Functional elements required for SCPI commands.
(7) Buffer size limitations for block data.
(8) Syntax restrictions.
(9) Response syntax for every query command.
(10) Device-to-device message transfer that does not follow
rules of the standard.
(11) Block data response size.
(12) Common Commands implemented by Model 2500.
(13) Calibration query information.
(14) Trigger macro for *DDT.
(15) Macro information.
(16) Response to *IDN (identification).
(17) Storage area for *PUD and *PUD?.
(18) Resource description for *RDT and *RDT?.
(19) Effects of *RST, *RCL and *SAV.
(20) *TST information.
(21) Status register structure.
(22) Sequential or overlapped commands.
(23) Operation complete messages.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
Requirements
IEEE-488 and SCPI Conformance Information
Description or reference
See Appendix
Cannot enter an invalid address.
Address changes and bus resets.
Determine by :SYSTem:POSetup. See
Section 17.
2048 bytes.
None.
All queries (Common Commands and
SCPI).
None.
See Table E-2.
Contained in SCPI command sub-
systems tables (see
Table 17-10).
Block display messages: 32 characters
max.
See Section 13,
See Section 13,
None.
See Section 17,
See Section 15,
See Service Manual.
Not applicable.
Not applicable.
See Section 15,
Not applicable.
Not applicable.
See Section 15,
See Section 15,
See Section 14,
All are sequential except :INIT.
*OPC, *OPC? and *WAI; see
Section 15,
D.
Table 17-1 through
"Programming syntax."
"Programming syntax."
"FORMat subsystem."
"Common Commands."
"Common Commands."
"Common Commands."
"Common Commands."
"Status Structure."
"Common Commands."
E-3