Calculate6; Select Delta Calculation Mode; Format <Name; Enable And Read Delta Result - Keithley 2500 User Manual

17-30 SCPI Command Reference

CALCulate6

The CALC6 commands control the delta function. They perform the remote equivalents to
the front panel DELTA and CONFIG DELTA configuration menu.

Select DELTA calculation mode

FORMat <name>
:CALCulate6:FORMat <name>
Parameters
Query
Description

Enable and read DELTA result

STATe <b>
:CALCulate6:STATe <b>
Parameters
Query
Description

DATA?

:CALCulate6:DATA?
Description
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
<name> = C3C4
C4C3
:FORMat?
This command selects the DELTA calculation mode. With C3C4
selected, the CALC4 result (channel 2 REL) is subtracted from the
CALC3 result (channel 1 REL). With C4C3 selected, the CALC3 result
is subtracted from the CALC4 result.
<b> = 1 or ON
0 or OFF
:STATe?
This command is used to enable or disable DELTA mode. When
enabled, the CALC6 reading will be DELTA value determined by
FORMat (above). When disabled, or if a divide by zero error occurs, the
CALC6 reading will return a NAN (not a number) value of +9.91e37.
This query command is used to read the result of the CALC5 ratio cal-
culation. When enabled, the CALC5 reading will be ratio value deter-
mined by FORMat (above). When disabled, or if a divide by zero error
occurs, the CALC5 reading will return a NAN (not a number) value of
+9.91e37.
Models 2500 and 2502 User's Manual
Configure and control DELTA function
Select DELTA calculation mode
CALC3 - CALC4
CALC4 - CALC3
Query selected DELTA calculation
Control DELTA
Enable DELTA
Disable DELTA
Query state of DELTA
Read DELTA result