Models 2500 and 2502 User's Manual
Photodiode measurement programming example
Table 4-3
using channel 1 to measure the current of the back photodiode detector, and channel 2
displaying optical power. Note that the steps correspond to those listed previously in
"Front panel photodiode measurement procedure."
for basic connections and
These commands set up the Model 2500 as follows:
• Channel 1 measurement: current measurement, auto range
• Channel 2 measurement: optical power
• Channel 2 responsivity constant (R) of detector for wavelength of interest: 1
• Channel 2 dark current (D): 1
• Channel 1 source: 10V range, +10V amplitude
• Channel 2 source: 100V range, +20V amplitude
NOTE
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
summarizes the command sequence for a photodiode measurement procedure
Section 2
See
Appendix H
for a complete program listing.
Photodiode Measurements
See
Figure 4-2
for detailed connection information.
4-7
earlier in this section