Keithley 2500 User Manual page 53

Model 2500 and 2502 User's Manual
Table 1-4 (continued)
Main menu
1
Menu item
3
CAL
TEST
4
DISPLAY-TESTS
KEYS
DISPLAY-PATTERNS
CHAR SET
A/D CTRL
5
AUTO-ZERO
DISABLE
ENABLE
LINE-FREQUENCY
GENERAL
DIGOUT
SERIAL#
TIMESTAMP
NUMBERS
Notes:
1
Top level menu choices indicated in bold. Indentation identifies each lower submenu level.
2
When the remote operation interface selection (GPIB or RS-232) is changed, the Model 2500 performs a power-on reset. To check
or change options of the selected interface, you must re-enter the menu structure.
3
Password is required to unlock calibration. (See Service Manual.)
4
Press EXIT key to cancel test.
5
Disabling auto zero will reduce measurement accuracy.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
Description
Calibrate Model 2500.
Perform tests on Model 2500.
Test front panel keys and display digits.
Test front panel keys.
Test display pixels and annunciators.
Test special display characters.
Control auto zero, line frequency, and NPLC caching.
Control auto zero.
Disable auto zero.
Enable auto zero.
Set the line frequency.
Select general operations.
Set Digital I/O port bit pattern.
Display serial number, firmware revision, SCPI
version.
Reset timestamp.
Select engineering units or scientific notation display
format.
Getting Started 1-21
Parameters
50 or 60Hz
0-15
YES or NO
ENGR,
SCIENTIFIC