Table of Contents
Advertisement
M2M Cellular Gateway
Go to Advanced Network > Communication Bus > Port Configuration tab
Port Configuration Window
Item
Value setting
Serial Port
N/A
Operation Mode
Disable is set by default
Interface
RS‐232 is set by default
Baud Rate
19200 is set by default
Data Bits
8 is set by default
1 is set by default
Stop Bits
Flow Control
None is set by default
Parity
None is set by default
Action
N/A
Save
N/A
To switch from one operation mode to the next
Click Edit button. Then select Virtual COM, Modbus or IEC 60870‐5 from the dropdown box.
Index skipping is used to reserve slots for new function insertion, when required.
Description
It displays the serial pot ID of the serial port.
It displays the current selected mode of operation for the serial interface.
Depending on the model purchased the available mode are Virtual COM,
Modbus, and IEC 60870‐5.
Select RS‐232 or RS‐485 connection to map to IP‐based network.
Select the appropriate baud rate for serial device communication
RS‐232: 9600 / 19200 / 38400 / 57600 / 115200
RS‐485: 9600 / 19200 / 38400 / 57600 / 115200 / 230400 / 460800
Select 8 or 7 for data bits
Select 1 or 2 for stop bits
Select None / RTS,CTS / DTS, DSR for Flow Control
Select None / Even / Odd for Parity bit
Edit buttons to select the mode of operation and modify the parameters
mentioned above for the serial interface communication.
Click Save button to save the settings.
298
Advertisement
Table of Contents
