M2M IDG500AM-0T001 User Manual page 146

M2M Cellular Gateway
Source IP
A Must filled setting
Destination IP
A Must filled setting
Source MAC
A Must filled setting
Protocol
A Must filled setting
Index skipping is used to reserve slots for new function insertion, when required.
Please note that two identical interfaces are not accepted by the router. i.e. VLAN‐
1 to VLAN‐1.
This field is to specify the Source IP address.
Select Any to filter packets coming from any IP addresses.
Select Specific IP Address to filter packets coming from an IP address.
Select IP Range to filter packets coming from a specified range of IP address.
Select IP Address‐based Group to filter packets coming from a pre‐defined group.
Note: group must be pre‐defined before this option become available. Refer to
System > Grouping > Host grouping. You may also access to create a group by the
Add Rule shortcut button.
This field is to specify the Destination IP address.
Select Any to filter packets that are entering to any IP addresses.
Select Specific IP Address to filter packets entering to an IP address entered in this
field.
Select IP Range to filter packets entering to a specified range of IP address entered
in this field.
Select IP Address‐based Group to filter packets entering to a pre‐defined group
selected. Note: group must be pre‐defined before this selection become available.
Refer to System > Grouping > Host grouping. You may also access to create a
group by the Add Rule shortcut button. Setting done through the Add Rule button
will also appear in the Host grouping setting screen.
This field is to specify the Source MAC address.
Select Any to filter packets coming from any MAC addresses.
Select Specific MAC Address to filter packets coming from a MAC address.
Select MAC Address‐based Group to filter packets coming from a pre‐defined
group selected. Note: group must be pre‐defined before this selection become
available. Refer to System > Grouping > Host grouping. You may also access to
create a group by the Add Rule shortcut button.
For Protocol, select Any to filter any protocol packets
Then for Source Port, select a predefined port dropdown box when Well‐known
Service is selected, otherwise select User‐defined Service and specify a port range.
Then for Destination Port, select a predefined port dropdown box when Well‐
known Service is selected, otherwise select User‐defined Service and specify a
port range.
For Protocol, select ICMPv4 to filter ICMPv4 packets
For Protocol, select TCP to filter TCP packets
Then for Source Port, select a predefined port dropdown box when Well‐known
Service is selected, otherwise select User‐defined Service and specify a port range.
Then for Destination Port, select a predefined port dropdown box when Well‐
known Service is selected, otherwise select User‐defined Service and specify a
port range.
For Protocol, select UDP to filter UDP packets
Then for Source Port, select a predefined port dropdown box when Well‐known
Service is selected, otherwise select User‐defined Service and specify a port range.
Then for Destination Port, select a predefined port dropdown box when Well‐
146