M2M Cellular Gateway
Configuration Path
IPSec
Configuration Path
Tunnel
Tunnel Name
Interface
Tunnel Scenario
Operation Mode
Configuration Path
Local Subnet
Local Netmask
Full Tunnel
Remote Subnet
Remote Netmask
Remote Gateway
Configuration Path
Key Management
Local ID
Remote ID
Configuration Path
Negotiation Mode
X‐Auth
For Network‐B at Branch Office
Following 5 tables list the parameter configuration for above example diagram of IPSec
VPN tunnel in Network‐B.
Use default value for those parameters that are not mentioned in these 5 tables.
Please also note that the authentication parameters of both peers must match each
other to successfully establishing authentication process, and it is just for an example
here.
Besides, Negotiation Mode and X‐Auth in "IKE Phase" configuration window should be
also matched in both peers.
And there is at least one proposal entity in IKE Proposal Definition and at least one
proposal entity in IPSec Proposal Definition are same for both peers. Use the default
ones in the setup example and they are not shown in followings.
Configuration Path
IPSec
Index skipping is used to reserve slots for new function insertion, when required.
[IPSec]‐[Configuration]
■ Enable
[IPSec]‐[Tunnel Configuration]
■ Enable
s2s‐101
WAN 1
Site to Site
Always on
[IPSec]‐[Local & Remote Configuration]
10.0.76.0
255.255.255.0
Disable
10.0.75.0
255.255.255.0
118.18.81.33
[IPSec]‐[Authentication]
IKE+Pre‐shared Key 12345678
User Name Network‐A
User Name Network‐B
[IPSec]‐[IKE Phase]
Main Mode
None
[IPSec]‐[Configuration]
■ Enable
184