Table of Contents
Advertisement
M2M Cellular Gateway
Local & Remote Configuration Window
Item
Value setting
A Must fill setting
Local Subnet List
Unchecked by
Full Tunnel
default
Remote Subnet List
A Must fill setting
1. A Must fill setting.
2. Format can be a
Remote Gateway
ipv4 address or
FQDN
Authentication Configuration Window
Item
Value setting
1. A Must fill setting
Key Management
2. Pre‐shared Key 8
to 32 characters.
Local ID
An optional setting
Remote ID
An optional setting
IKE Phase Configuration Window
Index skipping is used to reserve slots for new function insertion, when required.
Description
Specify the Local Subnet IP address and Subnet Mask.
Click the Add or Delete button to add or delete a Local Subnet.
Note_1: When Dynamic VPN option in Tunnel Scenario is selected, there will be
only one subnet available.
Note_2: When Host‐to‐Site or Host‐to‐Host option in Tunnel Scenario is selected,
Local Subnet will not be available.
Note_3: When Hub and Spoke option in Hub and Spoke is selected, there will be
only one subnet available.
Click Enable box to enable Full Tunnel.
Note: Full tunnel is available only for Site‐to‐Site specified in Tunnel Scenario.
Specify the Remote Subnet IP address and Subnet Mask.
Click the Add or Delete button to add or delete Remote Subnet setting.
Specify the Remote Gateway.
Description
Select Key Management from the dropdown box for this IPSec tunnel.
IKE+Pre‐shared Key user need to set a key (Min. 8 characters).
IKE+X.509 user need Certificate to authenticate. IKE_X.509 will be available only
when Certificate has been configured properly. Refer to Certificate section of this
manual and also Advanced Network> Certificate in web‐based utility.
Manually user needs to enter l key to authenticate. Manual key configuration will
be explained in the Manual Key Management section located in the following next
2 pages.
Specify the Local ID for this IPSec tunnel to authenticate.
Select User Name for Local ID and enter the username. The username may include
but can't be all numbers.
Select FQDN for Local ID and enter the FQDN.
Select User@FQDN for Local ID and enter the User@FQDN.
Select Key ID for Local ID and enter the Key ID (English alphabet or number).
Specify the Remote ID for this IPSec tunnel to authenticate.
Selected User Name for Remote ID and enter the username. The username may
include but can't be all numbers.
Select FQDN for Local ID and enter the FQDN.
Select User@FQDN for Remote ID and enter the User@FQDN.
Select Key ID for Remote ID and enter the Key ID (English alphabet or number)..
Note: Remote ID will be not available when Dynamic VPN option in Tunnel Scenario
is selected.
196
Advertisement
Table of Contents
