M2M IDG500AM-0T001 User Manual page 214

M2M Cellular Gateway
Subnet
1. A Must fill setting
Authentication
2. Unchecked by
Protocol
default
1. Unchecked by
default
MPPE Encryption
2. an optional setting
1. Unchecked by
NAT before
default
Tunneling
2. an optional setting
Auto is set by default
LCP Echo Type
Unchecked by
Tunnel
default
Save
N/A
Undo
N/A
Back
N/A
Index skipping is used to reserve slots for new function insertion, when required.
the PPTP server then select Default Gateway, otherwise, specified a subnet and its
netmask –the remote subnet, if the default gateway is not used to connect to the
PPTP server.
The Remote Subnet format must be IP address/netmask (e.g. 10.0.0.2/24).
Specify one ore multiple Authentication Protocol for this PPTP tunnel.
Available authentication methods are PAP/CHAP/MS‐CHAP/MS‐CHAPv2
Specify whether PPTP server supports MPPE Protocol. Click the Enable box to
enable MPPE.
Note: when MPPE Encryption is enabled, the Authentication Protocol PAP/CHAP
options will not be available.
Check the Enable box to enable NAT function for this PPTP tunnel.
Specify the LCP Echo Type for this PPTP tunnel. Auto, User‐defined, Disable.
Auto the system sets the Interval and Max. Failure Time.
User‐defined enter the Interval and Max. Failure Time.
Disable disable the LCP Echo.
Check the Enable box to enable this PPTP tunnel.
Click Save button to save the settings.
Click Undo button to cancel the settings.
Click Back button to return to the previous page.
214