M2M IDG500AM-0T001 User Manual page 263

M2M Cellular Gateway
NMS and the managed devices, use SNMPv3 version of protocol.
The remote NMS without privilege IP address can't manage the "Gateway 1", since
"Gateway 1" allows only the NMS with privilege IP address can manage it via its WAN
interface.
SNMP Setting
The SNMP allows user to configure SNMP relevant setting which includes interface, version,
access control and trap receiver
Ensure Configuration are enabled and saved
Go to Advanced Network > System Management > SNMP
SNMP
Item
SNMP Enable
Supported Versions
Remote Aceess IP
SNMP Port
Index skipping is used to reserve slots for new function insertion, when required.
Value setting Description
1.The LAN box is
checked by default
1.The v1 box is
checked by default
2.The v2c box is
checked by default
1. String format: any
Ipv4 address
2. It is an optional
item.
1. String format: any
Select the interface for the SNMP and enable SNMP functions.
When Check the LAN box.
It will activate SNMP functions and you can access SNMP by LAN
When Check the WAN box.
It will activate SNMP functions and you can access SNMP by WAN
Select the version for the SNMP
When Check the v1 box.
It means you can access SNMP by version 1.
When Check the v2c box.
It means you can access SNMP by version 2c.
When Check the v3 box.
It means you can access SNMP by version 3.
Specify the Remote Aceess IP for WAN.
If you filled in the IP address. It means only this IP address can access SNMP by
WAN.
If you not filled. It means any IP address can access SNMP by WAN.
Specify the SNMP Port.
263