3.3.2.10 Coders And Profiles; Figure 3-88: Radius Parameters Page - AudioCodes Mediant 600 User Manual

5. To save the changes to flash memory, see ''Saving Configuration'' on page 197.
Click the Proxy Set Table
groups of proxy addresses. Alternatively, you can open this page from the Proxy Sets
Table page item (see ''Configuring Proxy Sets Table'' on page
page).
3.3.2.9.5 Configuring Accounting Settings
The 'RADIUS Parameters' page allows you to configure the RADIUS parameters. For a
description of the parameters appearing on this page, see ''Configuration Parameters
Reference'' on page 501.

To configure the RADIUS parameters:
1. Open the 'RADIUS Parameters' page (Configuration tab > VoIP menu > SIP
Definitions submenu > Accounting Settings).
2. Configure the parameters as required.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 197.

3.3.2.10 Coders and Profiles

The Coders And Profile Definitions submenu includes the following page items:

Coders (see ''Configuring Coders'' on page 133)

Coders Group Settings (see ''Configuring Coder Groups'' on page 134)

Tel Profile Settings (see Configuring Tel Profiles on page 135)

IP Profile Settings (see Configuring IP Profiles on page 137)
Implementing the device's Profile features provides the device with high-level adaptation
when connected to a variety of equipment (at both Tel and IP sides) and protocols, each of
which requires different system behavior. Each Profile contains a set of parameters such
as coders, T.38 Relay, Voice and DTMF Gain, Silence Suppression, Echo Canceler, RTP
DiffServ, Current Disconnect and more. The Profiles feature allows you to customize these
parameters or turn them on or off, per source or destination routing and/or per the device's
trunks (channels). For example, specific E1/T1 spans can be assigned a Profile that always
uses G.711.
Each call can be associated with one or two Profiles - Tel Profile and/or IP Profile. If both
IP and Tel Profiles apply to the same call, the coders and other common parameters of the
preferred Profile (determined by the Preference option) are applied to that call. If the
Preference of the Tel and IP Profiles is identical, the Tel Profile parameters take
precedence.
You can assign different Profiles (behavior) per call, using the call routing tables:

'Outbound IP Routing Table' page (see Configuring the Outbound IP Routing Table on
page 159)

'Inbound IP Routing Table' page (see Configuring the Inbound IP Routing Table on
SIP User's Manual
button to open the 'Proxy Sets Table' page to configure

Figure 3-88: RADIUS Parameters Page

132
Mediant 600 & Mediant 1000
120 for a description of this
Document #: LTRT-83308