Options And Accessories; Mounting Of Option Modules In Slot A; Mounting Of Option Modules In Slot B - Danfoss FC 300 Design Manual

FC 300 Design Guide

10 Options and Accessories

Danfoss offers a wide range of options and accessories for VLT AutomationDrive.

10.1.1 Mounting of Option Modules in Slot A

Slot A position is dedicated to Fieldbus options. For further information, see separate operating instructions.

10.1.2 Mounting of Option Modules in Slot B

The power to the frequency converter must be disconnected.
It is strongly recommended to make sure the parameter data is saved (i.e. by MCT10 software ) before option modules are inserted/removed from the
drive.
• Remove the LCP (Local Control Panel), the terminal cover, and the LCP frame from the frequency converter.
• Fit the MCB10x option card into slot B.
• Connect the control cables and relieve the cable by the enclosed cable strips.
* Remove the knock out in the extended LCP frame, so that the option will fit under the extended LCP frame.
• Fit the extended LCP frame and terminal cover.
• Fit the LCP or blind cover in the extended LCP frame.
• Connect power to the frequency converter.
• Set up the input/output functions in the corresponding parameters, as mentioned in the section
Frame sizes A2, A3 and B3
MG.33.BC.02 - VLT ® is a registered Danfoss trademark
10 Options and Accessories
General Technical Data
Frame sizes A5, B1, B2, B4, C1, C2, C3 and C4
.
10
207