Danfoss FC 300 Design Manual page 252

11 RS-485 Installation and Set-up
Bits 13/14, Set-up selection
Bits 13 and 14 are used to choose between the four parameter set-ups
according to the following table:
The function is only possible if
Active Set-up
par. 0-10
mines how bits 13 and 14 are linked with the corresponding function of
the digital inputs. Changing set-up while running is only possible if the
set-ups have been linked in par. 0-12
Bit 15, No function/Reverse
Bit 15 = "0" causes no reversing.
Bit 15 = "1" causes reversing.
Note: In the factory setting reversing is set to
NB!
Bit 15 causes reversing only when
11.10.6 Status Word according to PROFIdrive Profile (STW)
The Status word is used to notify a master (e.g. a PC) about the status
of a slave.
11
Explanation of the Status Bits
Bit 00, Control not ready/ready
When bit 00 = "0", bit 00, 01 or 02 of the Control word is "0" (OFF 1, OFF 2 or OFF 3) - or the frequency converter is switched off (trip).
When bit 00 = "1", the frequency converter control is ready, but there is not necessarily power supply to the unit present (in the event of external 24 V
supply of the control system).
Bit 01, VLT not ready/ready
Same significance as bit 00, however, there is a supply of the power unit. The frequency converter is ready when it receives the necessary start signals.
252
Multi Set-up
has been chosen in
Set-up Select
. The selection in par. 8-55
This Set-up Linked to
.
digital
in par. 8-54
Ser. communication, Logic or
MG.33.BC.02 - VLT
Set-up
1
2
3
4
deter-
Reversing Select
.
Logic and
or is selected.
Bit Bit = 0
00 Control not ready
01 Drive not ready
02 Coasting
03 No error
04 OFF 2
05 OFF 3
06 Start possible
07 No warning
Speed ≠ reference
08
09 Local operation
10 Out of frequency limit
11 No operation
12 Drive OK
13 Voltage OK
14 Torque OK
15 Timer OK
® is a registered Danfoss trademark
FC 300 Design Guide
Bit 13 Bit 14
0 0
1 0
0 1
1 1
Bit = 1
Control ready
Drive ready
Enable
Trip
ON 2
ON 3
Start not possible
Warning
Speed = reference
Bus control
Frequency limit ok
In operation
Stopped, autostart
Voltage exceeded
Torque exceeded
Timer exceeded