All terminals to the control cables are located underneath the terminal cover on the front of the frequency converter. Remove the terminal cover by means

of a screwdriver (see illustration).

Illustration 8.33: Frame sizes A1, A2, A3,B3, B4, C3 and C4

8.6.2 Control Cable Routing

Tie down all control wires to the designated control cable routing as shown in the picture. Remember to connect the shields in a proper way to ensure

optimum electrical immunity.

Fieldbus connection

Connections are made to the relevant options on the control card. For details see the relevant fieldbus instruction. The cable must be placed to the left

inside the frequency converter and tied down together with other control wires (see picture).

Control card wiring path for the D3. Control card wiring for the D1, D2,

D4, E1 and E2 use the same path.

178

Illustration 8.34: Frame sizes A5, B1, B2, C1 and C2

Control card wiring path for the F1/F3. Control card wiring for the F2/F4

use the same path.

MG.33.BC.02 - VLT

is a registered Danfoss trademark

FC 300 Design Guide

Table of Contents