Danfoss FC 300 Design Manual page 221

FC 300 Design Guide
10.9.1 Combinations
The following table shows which combinations can be realized.
Option Mounting in the MCF 106 ID
A 6)
Yes
Yes 6)
Yes 6)
7)
Yes
B Yes
No
Yes
Yes
Yes
No
C0 No
No
No
No
C1 No
No
D No
Table 10.1: Overview of different possibilities for combinations. Look up one of the options in question and see which additional options this can be
combined with, if MCF 106 is used and if only the standard drive is used. A list of limitations and exceptions can be found below.
1) One B less if MCA 121 EthernetIP is used
2) Does not incl. MCA 121 EthernetIP
3) MCB 105 and MCB 112 must always be installed in the standard B slot of the Control Card and can thus never be combined
4) Can only incl B if A is not MCA 121 EtherNetIP
5) One C1 option can be added on top of the MCO 305 in the bookstyle enclosures (A2, A3 and B3)
6) Only in E0slot
7) Only in E1 slot
NB!
Two identical options can n ot be installed at the same time
Name
MCA 101 Profibus DP V1
MCA 104 DeviceNet
MCA 105 CanOpen
MCA 121 EtherNetIP
MCB 102 Encoder option
MCB 105 Relay option 3)
MCB 101 General Purpose I/O
MCB 103 Resolver option
MCB 108 PLC Safe Interfece
MCB 112 PTC Thermistor Card 3)
MCO 305 Programmable Motion Control None
MCO 350 Synchronizing Control
MCO 351 Positioning Sontrol
MCO 352 Center Winder
MCA 103 ProfiSafe-Safe Stop
MCB 113 Stt. Relay Card
MCB 107 24V External Supply
MG.33.BC.02 - VLT ® is a registered Danfoss trademark
10 Options and Accessories
Possible combinations
with MCF 106 without MCF 106
+ 3B + D + B + C + D
+ 3B + D + B + C + D
+ 3B + D + B + C + D
+ 2B + D + C + D
+ A + 2B 1) + D + A 2) + C + D
+ A + 2B 1) + D + A 2) + C + D
1) 2)
+ A + 2B + D + A + C + D
+ A + 2B 1) + D + A 2) + C + D
+ A + 2B 1) + D + A 2) + C + D
1) 2)
+ A + 2B + D + A + C + D
+ A + B 4) + C! 5) + D
None + A + B 4) + D
None 4)
+ A + B + D
None
+ A + B 4) + D
None + A + B 4) + D
None 4)
+ A + B + D
+ A + 3B 1) + A + B 4) + C
10
221