Table of Contents
Advertisement
Removing the server top cover and bezel (rack configuration)
This section describes how to remove the top cover and bezel from the rack
configuration server.
Removing the top cover
The following illustration shows how to remove the top cover from a rack
configuration server.
Complete the following steps to remove the server top cover:
1. Review the information in "Safety" on page v, "Installation guidelines" on
2. Press down on the plastic cover-release latch on the front of the server.
3. While pressing the plastic cover-release latch, slide the top cover slightly toward
16
IBM xSeries 235 Type 8671: Installation Guide
page 11, and "Handling static-sensitive devices" on page 12.
the rear of the server; the cover will stop after approximately 25 mm (1 inch).
Lift the cover off the server and set the cover aside.
Attention:
For proper cooling and airflow, replace the server cover before
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the server cover removed might damage server components.
Top cover
Right-side
latch
Cover-release latch
Left-side latch
Advertisement
Table of Contents
