Installing An Ibm Virtual Media Key - IBM System x iDataPlex dx360 M3 User Manual

10. Insert the DIMM into the connector by aligning the edges of the DIMM with the
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 45.

Installing an IBM virtual media key

To install an IBM virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the system-board tray and all attached devices (see "Turning off the
3. If the system-board tray is installed in a chassis, remove it (see "Removing a
44
System x iDataPlex dx360 M3: User's Guide
Attention: To avoid breaking the DIMM retaining clips or damaging the
DIMM connectors, open and close the clips gently.
7. Open the retaining clips and, if necessary, remove any existing DIMM.
8. Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the system-board tray; then, remove the DIMM from the
package.
9. Turn the DIMM so that the DIMM keys align correctly with the connector on the
system board.
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector.
Attention: If there is a gap between the DIMM and the retaining clips, the
DIMM has not been correctly installed. Open the retaining clips, remove the
DIMM, and then reinsert it.
on page 23.
system-board tray" on page 21).
system-board tray from a 2U chassis" on page 25 or "Removing a system-board
tray from a 3U chassis" on page 27).