Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 97

Inheriting server blade configuration information for N+M cold standby
This section provides setting information to be taken over at failover by N+M
cold standby.
Server blade in basic mode
When switching N+M cold standby in basic mode, the standby server blade
inherits the following information from the active server blade.
WWN
MAC
Server blade
configuration (UEFI/
9
BMC)
HBA BIOS
configuration of Fibre
Channel mezzanine
card
Emulex 10 Gb
CNA/LAN mezzanine
card, onboard CNA (2
or 4 ports)
configuration
Server blade
configuration (SVP)
Notes:
1 Inheriting Optional Physical WWN. For details, see
.
2-54.
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-81 Inheriting items
Division
World Wide Node Name
World Wide Port Name
Media Access Control address
MAC categorization
BMC time setting procedure, Time zone
setting
Schedule data
EFI setting
Boot order
HBA BIOS enable/disable setting
Boot priority enable/disable setting
Boot target WWN
Boot target LUN
PXE Boot setting
VLAN setting
Bandwidth setting at port partitioning
SR-IOV (when the MultiChannel Support
setting is disabled)
(When MultiChannel Support setting is
enabled)
iSCSI setting
Power supply control linkage setting
N+M cold standby support function setting
OS type
(with LPAR manager / without LPAR
manager)
Functional detail
Item
11
11
WWN and MAC addresses on page
Remarks
1
2
3
-
-
4
-
5
6
7
8
-
2-73