Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 355

ID
FF08 WARNING
[Meaning] In a device at the part shown in X, the time synchronization is not available
using NTP server.
[Action] Check if communication between the management module and NTP server is
available. Also check the configuration of management module and NTP server.
Check if the specified parts time is correct, correct the time as needed.
FF09 Info
[Meaning] In a device at the part shown in X, the time synchronization is resumed using
NTP server.
[Action] Check if the specified parts time is correct, correct the time as needed.
FF0B FAIL
[Meaning] Support center report is not available due to failure in report function x.
[Action] Contact your reseller or call for maintenance personnel.
FF0E WARNING
[Meaning] A report at the part shown in X failed.
[Action] Check if communication between the information addressee and management
module is available. Also check the report configuration, and correct the configuration as
needed. If the problem persists, consult your reseller or maintenance personnel.
FF0F Info
[Meaning] A report at the part shown in X is resumed.
[Action] No particular action required.
FF10 Info
[Meaning] In a device at the part shown in X, power saving event is logged. Y shows the
event type.
[Action] No particular action required.
FF11 WARNING
[Meaning] In a device at the part shown in X, power saving event as warning level is
logged. Y shows the event type.
[Action] Check if the power saving configuration is correct, correct the configuration as
needed.
FF18 Info
[Meaning] In a device at the part shown in X, maintenance mode is started.
This message may be appeared several times depending on the maintenance type.
[Action] No particular action required.
FF19 Info
[Meaning] In a device at the part shown in X, maintenance mode is ended.
Hitachi Compute Blade 500 Series Management Module Setup Guide
Level
Description
The synchronization of time is not
performed.(Location:X)
The synchronization of time is resumed.
(Location:X)
Support center report failed.(Report:X)
A report is failed.(Report:X)
A report is resumed.(Report:X)
Power saving event was occurred.
(Location:X,Event:Y)
Power saving <warning> event was
occurred.(Location:X,Event:Y)
On <X>, maintenance mode is started.
On <X>, maintenance mode is ended.
HCSM alert log message
Message
A-11