Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 314

minutes later. When you find the updated version, there is no problem. If
you cannot connect to the Web console to check the version, contact your
reseller or maintenance personnel.
When the management module is not updated:
10 When the management module firmware is updated, the active one will
.
reboot to disconnect. Close the browser.
Note: If the management module is not updated, you need not to close
the browser. Then, proceed to
(4) Checking new versions
This subsection describes how to check the latest versions, which were
obtained in
firmware/Dictionary/Equipment parameter on page
properly applied.
Note: When the management module firmware has been updated, you need
to execute step 1 through step 4. The active management module reboots,
and then the other one reboots.
Wait for about ten minutes after the other management module completely
reboots up. Then, open the browser and log in to the management module.
Login is not available while the management module is rebooting. If so, wait
for a few minutes and then try again.
1 Open the browser, type User ID and Password, and click Log In to log
.
in to the management module.
2 Click Resources tab.
.
3 Click All Modules > Management Modules.
.
4 Check that Hot standby status of both management modules is the same
.
as that before updating, which means that the management module
firmware has been completely updated.
2-290
Hitachi Compute Blade 500 Series Management Module Setup Guide
(1) Obtaining the latest versions of Management module
Functional detail
(4) Checking new versions on page
2-285, have been
2-290.