Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 46

• When the management module firmware version is A0125 or earlier at
shipment, "Not apply this Default Gateway setting to the LAN switch
module." is checked. Updating the firmware cannot change this setting. If
you keep this setting checked, directly log into the LAN switch module
console to set the default gateway.
Tip: If you uncheck "Not apply this Default Gateway setting to the LAN switch
module." the default gateway setting of the internal LAN switch is changed by
the management module, which may affect your network.
IP address settings
To connect to the management interface of each module, set the following
items. If you are using an IPv6 network, set both IPv4 addresses and IPv6
addresses.
IPv4
network
IPv6
network
Note:
• Even if you connect to a management module through an IPv6 network,
you cannot delete the IPv4 address.
• If you use the Web console or CLI console to change an IPv4 address that
is connected to the management module, the IPv4 connection is
disconnected.
2-22
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-29 IP address setting screen
Item
IPv4 address To the management interface of a module through an
IPv4 network, set the IPv4 address, subnet mask, and
Subnet mask
default gateway.
Default gateway
Static IPv6 To the management interface of a module through an
address address IPv6 network, set the IPv6 address, prefix, and
default gateway.
Subnet
Set IPv6 addresses in the format specified in
mask
RFC4291.
Default
Refer to the following URL when setting addresses:
gateway
https://www.iana.org/assignments/ipv6-
address-space/ipv6-address-space.xhtml
Stateless address Enable or disable Stateless Address Autoconfiguration
(SLAAC).
If this setting is enabled, based on the prefix
distributed by the router and the interface ID (MAC
address), an IPv6 address is automatically generated
and assigned to the management interface of the
module.
You can enable or disable SLAAC for management
modules and server blades.
Functional detail
Screen