Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 266

•
• SMTP authentication parameter
Three items of SMTP server authentication are shown below.
¢
¢
¢
• Encryption parameter
The following item is for setting encryption parameter.
Encryption for SMTP path
Note: When Security strength is set to high for the management module,
configure TLS for the encryption version for e-mail notification route, and
CRAM-MD5 for SMTP authentication method. If not configured, e-mail is not
sent.
Setting destination address information
Set the following items for e-mail notification destination.
• Destination address parameter
Three items of destination information are shown below.
¢
¢
¢
Displaying/setting e-mail
notification
Displaying/setting e-mail
destinations
Displaying setting for E-mail
Setting notification information by E-mail
Setting/adding destination address
Deleting destination address
2-242
Hitachi Compute Blade 500 Series Management Module Setup Guide
The management module does not support the email notification
function that uses IPv6 stateless addresses.
To communicate with the SNMP server by using IPv6 addresses,
disable the stateless address setting of the management module.
Enabling/disabling SMTP authentication
Account
Authentication method
Nickname
E-mail address
Attach log file
Table 2-130 Web console operation
Item
Table 2-131 CLI console command
Item
Functional detail
Operation
Administration tab > E-Mail Notification >
Notification Settings tab
Administration tab > E-Mail Notification >
Destinations Settings tab
show e-mail mgmt-lan
set e-mail mgmt-lan notification
set e-mail mgmt-lan address
delete e-mail mgmt-lan address
Command