Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 17

Figure 1-1 Port location of management module
Table 1-1 Port type of management module
Port name
Management LAN
port (MGMT0)
Management LAN
port (MGMT1)
Maintenance LAN
port (MAINT)
Serial port (SER)
Tip: You need to prepare following items for LAN port connection.
• System console
• UTP cable (UTP-5 or higher)
• Client software for HTTP, Telnet, or SSH
The following table describes specification of the factory default network
settings for management module, which are required to connect to HTTP,
Telnet, or SSH.
Table 1-2 Network settings for management module (factory default
Item
IP address
Management module overview
Hitachi Compute Blade 500 Series Management Module Setup Guide
This port is connected to the management LAN.
For the factory default setting, this port is connected to the
management LAN.
This port is connected to the management LAN.
For the factory default setting, this port cannot be connected to
the management LAN.
For details, see Network on page
This port is dedicated for customer engineers for maintenance
purposes.
The user can not use this port.
This serial port is for the system console.
Use this port for the initial setting. You can also use this port
when the LAN port cannot be used or the system unit is
performed initial setting.
settings)
192.168.0.1
Specification
2-11.
Specification
1-3