Network Re-Configuration After Management Module Failure - Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual

Set DNS servers as follows.
Displaying/setting DNS servers
for IPv4 addresses
Displaying/setting DNS servers
for IPv6 addresses
Priority of IPv4/IPv6 addresses
Displaying DNS servers for IPv4 addresses
Specifying DNS servers for IPv4 addresses
Displaying of DNS servers for IPv6 addresses
Specifying DNS servers for IPv6 addresses
Displaying the priority of IPv4/IPv6 addresses
Specifying the priority of IPv4/IPv6 addresses

Network re-configuration after management module failure

Only the management interface of main management module is active when
installing two management modules in the system unit. The ports of standby
management module are usually closed. When the main management module
failure occurs, the standby management module becomes to main
management module to continue operations. The ports of standby
management module are opened, and the management interface of standby
management module changes to active status.
IP addresses are assigned to the management interface of the new main
management module as follows:
IPv4 address
IPv6 static address
2-24
Hitachi Compute Blade 500 Series Management Module Setup Guide
(1). 2001:2000::100:100
(2). 2001:2000::100:101
(3). 192.168.0.200
Note: The IP address 192.168.0.201 is the fourth priority, and the
server is not used.
Table 2-30 Web console operations
Item
Table 2-31 CLI console command
Item
Address type
Functional detail
Operation
Resources tab > Systems > Network >
Management LAN > DNS tab
show mgmt-module mgmt-lan
set mgmt-module dns
show mgmt-module mgmt-v6 setting
set mgmt-module dns
show mgmt-module mgmt-v6 setting
set mgmt-module dns
Address assignment
The same IP address as that of the previous main
management module is used. To connect to the
management interface of management modules, you
do not need to know which module is the main
management module.
Command