Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 261

¢
¢
Displaying/setting SNMP agent
settings
Displaying/setting SNMP manager
settings
Displaying SNMP agent settings
Setting SNMP agent settings
Displaying SNMP manager settings
Setting SNMP manager settings
Note: When registering an SNMP manager that has an IPv6 address and uses
SNMP v1 or v2c, specify an IPv6 address as the host name of the SNMP
manager. If you specify a host name, the management module cannot be
detected as a node on the SNMP manager.
When registering an SNMP manager that has an IPv4 address and uses SNMP
v1 or v2c, you can specify an IPv4 address or a host name as the host name.
When registering an SNMP manager that uses SNMP v3, you can specify
either an IP address or host name as the host name, regardless of whether
the address of the SNMP manager is an IPv4 or IPv6 address.
Tip: When Security strength is set to high for the management module,
configure the following SNMP settings.
• Agent setting
SNMP version: v1/v2/v3
• Manager setting
SNMP version: v3
Type of access: AuthPriv
Type of authentication: SHA
Type of encryption: AES
If not configured, no response is returned to the manager request and SNMP
trap is not issued.
Testing SNMP trap notification
Perform the SNMP trap notification test from the management module, and
then confirm whether the trap is notified to the SNMP manager. When the
Hitachi Compute Blade 500 Series Management Module Setup Guide
Encryption type
Encryption password
Table 2-124 Web console operation
Item
Table 2-125 CLI console command
Item
Functional detail
Operation
Administration tab > SNMP > SNMP agent
Administration tab > SNMP > SNMP manager
show snmp agent
set snmp agent
show snmp manager
set snmp manager
Command
2-237