Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 45

You cannot set IPv6 stateless addresses from the CLI console.
Table 2-28 LCD touch console operations
Displaying/setting the IPv4 address of management
module
Only IPv4 addresses can be set on the LCD touch console.
For the following LAN switch modules, you need not to configure their
authentication information.
• Hitachi 1 Gb/sec LAN switch module (20-port) version 10.7.K or later
• Hitachi 1/10 Gb/sec LAN switch module version 10.7.K or later
• Hitachi 1 Gb/sec LAN switch module (40-port) version 11.6.B or later
System units shipped on or after October 2012 come with authentication-
setting-free switch module versions.
When you do not apply the default gateway to the LAN switch module, check
"Not apply this Default Gateway setting to the LAN switch module." if it is not
checked on the following Edit IP Address dialog box. When you apply it,
uncheck "Not apply this Default Gateway setting to the LAN switch module." if
it is checked.
Note:
• If you set the default gateway, 0.0.0.0, to the internal LAN switch module
without checking "Not apply this Default Gateway setting to the LAN
switch module.", it is not applied. Then, directly log into the LAN switch
module console to set the default gateway.
Hitachi Compute Blade 500 Series Management Module Setup Guide
Item
Functional detail
Operation
System settings > Network
2-21