Change Log For Optional Physical Wwn And Mac Address - Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual

- If Personality for Emulex 10 Gb CNA mezzanine card or onboard 2-port CNA
is not set to FCoE, Current WWN and Default Physical WWN cannot be shown
and the following message appears.
[Web console]
Not card installed
Not exist WWN Information
[CLI console]
WWN information does not exist
- If Personality for onboard 4-port CNA is not set to FCoE, Current WWN and
Default Physical WWN cannot be shown and the following message appears.
[Web console]
Not card installed
Not exist WWN Information
[CLI console]
WWN information does not exist

Change log for Optional Physical WWN and MAC address

Each WWN and MAC address registers 1023 times change log, such as
continuing/ initializing/changing the Optional Physical WWN and MAC address
at N+M cold standby. You can confirm the change log by the management
module console. The change log registers the time, before and after the
change, and the method (by N+M cold standby failover or by the
management module console). Therefore, you can know that when N+M cold
standby failover occurs, and which values of WWN and MAC address changed.
You can confirm only the change log of Optional Physical WWN and MAC
address. The WWN and MAC address for LPAR manager cannot be confirmed
the change log.
Displaying the WWN change log
Displaying the MAC address
change log
Displaying the WWN change log
2-62
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-72 Web console operation
Item
Alerts tab > All logs > Optional Physical WWN
Change log
Alerts tab > All logs > Optional Physical MAC
Change log
Table 2-73 CLI console command
Item
Functional detail
Operation
Command
show log wwn-edit