Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 18

Subnet mask
HTTPS
HTTP
SSH
telnet
The network settings can be changed through the management module
console.
Tip: You need to prepare following items for serial port connection.
• System console
• Serial cable (RS-232C cross cable D-SUB 9-pin female-female connector)
• VT100 Terminal software (Hyper terminal or something)
When connecting the serial port of the management module, the following
table describes the communication parameter setting for the terminal
software.
Table 1-3 Communication parameters settings for terminal software
Communication speed
Data
Parity
Stop bit
Flow control
The communication speed can be configured to change through the
management module console.
When setting the serial port communication speed, use the active
management module, which causes the standby management module to
have the same setting values.
You need to log out of the serial port connection, from the active and standby
respectively, to reflect the new serial port communication speed on the
system unit. If changing a serial port communication speed when logging in
via serial port, log out of the connection once. If changing a serial port
communication speed when logging in via LAN port, not serial port, log in
with the previous communication speed and then log out. The new
communication speed will take effect at the next login.
Tip: The web console is not available through the serial port.
1-4
Hitachi Compute Blade 500 Series Management Module Setup Guide
Item
Item
Management module overview
Specification
255.255.255.0
Available
Available
Available
Available
Specification
9600 bps
8 bit
N/A
1 bit
N/A