Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 105

Smart Configure for becoming switchable status. The Smart Configure is
executed automatically by BSM Plus or HCSM.
Turning on system unit
When turning on/off the system unit after building N+M cold standby
configuration, the Smart Configure is executed automatically. And then the N
+M cold standby is restarted.
Changing server blade configuration
When changing server blade configurations as follows, the Smart Configure is
executed automatically by the management module. And then the
configuration information of the management module is updated.
• Mounting server blade in the server chassis
• Turning on the server blade
Server blade movement during running Smart Configure
The LED of the front panel is blinked in the server blade during executing the
Smart Configure. The server blade is momentarily turned on while blinking
LED. For details of blinking LED, see the Hitachi Compute Blade 500 Series
System Overview Guide.
Smart Configure runtime
The Smart Configure runtime is 3 – 15 minutes. The Smart Configure runtime
is changed depend on the server blade type, number of CPU, Memory, and
type/number of PCI card.
N+M cold standby configuration procedure
Each configuration of the Compute Blade, SAN, and BSM plus, need building
individually. For configuration of SAN, and BSM plus or HCSM, see the
documents of SAN, and BSM plus or HCSM.
The following workflow describes the N+M cold standby configuration
procedure.
Hitachi Compute Blade 500 Series Management Module Setup Guide
Functional detail
2-81