Audit Events To Transfer; Log Format - Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual

and manage Audit events in management modules and BMC using the syslog
server.
Note:
• Audit events at user operation with stopping a management module, such
as shutdown, restart, replacement, may not be sent depending on the
timing.
• When you shut down, restart, or switch a management module
immediately after performing some operation, or when the management
module fails immediately after your operation, Audit events may not be
sent depending on the timing.
• Only Audit events can be sent to the syslog server. Events as alert trigger
for SC/BSM or HCSM are not sent to the syslog server.
• Audit events in a management module are sent to the syslog server from
the management module. Audit events in BMC are sent to the syslog
server from BMC. You need to configure settings for transfer to the syslog
server in management modules and in BMC respectively.
• Syslog transfer for BMC is not supported by CB 520A A1 and CB 540A
A1/B1 server blades.
• The following firmware versions support Syslog transfer for BMC.
- Server blade
CB 520H A1/B1: integrated firmware 01-92 or later
CB 520H B2: integrated firmware 04-22 or later

Audit events to transfer

Audit events are transferred when the events occur as operation logs or audit
logs. See

Log format

The following format is used for operation logs transferred to the syslog
server.
[date] [IP address for SVP or BMC] [mm or bmc]: auditevent,[log
message]
The following format is used for audit logs transferred to the syslog server.
[priority]1 [date] [IP address for SVP or BMC] [mm or bmc] -
[message ID] - [log message]
An operation log or audit log is in [log message]. See
log on page 2-265
"user" is displayed as facility for logs transferred to the syslog server. For
severity, "notice" is displayed as the result in the operation log or audit log
when an operation fails, and "info" is displayed when the operation result is
other than failure.
Hitachi Compute Blade 500 Series Management Module Setup Guide
Operation log and audit log on page 2-265
for the format and messages.
Functional detail
for details.
Operation log and audit
2-245