Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 102

Management module:
A0125 or later
Server blade firmware:
- For CB 520H A1/B1:Integrated FW 01-44 or later
- For CB 520A A1: Integrated FW 02-16 or later
Note: Use the firmware versions below to inherit the following settings in N
+M cold standby:
- The iSCSI setting of the Emulex 10 Gb CNA/LAN expansion cards for the CB
520H A1/B1, CB 520A A1 and CB 540A A1/B1 models.
- The iSCSI setting of the onboard CNA (2 ports)
Management module
A0135 or later
Server blade firmware
- For CB 520H A1/B1: Integrated FW 01-57 or later
- For CB 520A A1: Integrated FW 02-28 or later
- For CB 540A A1/B1: Integrated FW 03-09 or later
When Personality is iSCSI, you set the iSCSI settings for the standby server
blade as shown below.
• iSCSI Initiator IP address
0.0.0.0
• iSCSI Initiator SubnetMask
0.0.0.0
Note: To take over NIC settings for Emulex 10 Gb CNA/LAN mezzanine card
or for onboard 2-port CNA with N+M cold standby, use the following
configurations of firmware and driver versions shown in the table.
Configuration with LAN driver 4.2.390.6 or 4.2.456.0 and CNA firmware
4.1.334.28 or 4.1.334.2801 is not supported.
Note: The supported functionality of N+M cold standby including an enabled
Emulex 10 Gb onboard CNA (4 ports) varies depending on the firmware
version.
For the firmware versions below, only the Optional Physical MAC addresses
assigned to Emulex 10 Gb onboard CNAs (4 ports) on the active server blade
can be inherited by the standby server blade. For this reason, to use N+M
cold standby, you must specify the onboard CNA (4 ports) settings as
described below. If you do not, do not use N+M cold standby because it is not
supported.
• The Personality setting of the onboard CNA (4 ports) is either NIC or NIC
+RoCE.
2-78
Hitachi Compute Blade 500 Series Management Module Setup Guide
Functional detail